Easter Egg Tree

Since Easter is right around the corner, I was determined to make an Easter Egg Tree that was inspired by a post on Pinterest from Sweet Floweret  Unfortunately, I couldn't find any affordable glittered eggs, so I made my own.  I also, couldn't bring myself to spend $4.99 on a styrofoam cone, so I made the cone out of poster board from the dollar store.  I like to think of myself as a Thrifty Crafter - ok I'm CHEAP!

Since I made it out of a cone I was able to place it on a glass candlestick to raise it up.  I think it adds a little bit of elegance to it and also gives it more of a presence.

You will need - Mod Podge, Glitter - I used Sullyn from Hobby Lobby and some very fine purple that I've had for ages, 2 bags of small eggs (48), 1 bag of green paper grass, poster board, and a glass candlestick.

This is the messy part - Have Fun!  Paint each egg with Mod Podge, then cover in glitter.  I poured small amounts of both glitters onto a paper plate and then sprinkled them on to the Mod Podge covered egg that I placed in a small bowl.  Shaking the bowl to make the egg turn helps evenly cover the egg.  I let mine dry overnight, but they would probably dry in an hour or so.

Then it is time to make the cone.  Take a length of ribbon or string and tie one end on to a pencil.  Measure 12" out and tie a knot.

Hold the knot on the corner of the paper and make a mark from one side of the poster board to the other.

Then measure 2 inches on the ribbon from the pencil and a make another line in the corner of the poster board.

Next cut out the poster board.

Roll the poster board into a cone and secure it using tape.  You will want to end up with an opening instead of a point.  It will be a little off, but you can even it out with scissors.

Here it is with the little uneven bit cut off.

If you are going to place the cone on a candlestick you should trace the bottom of the cone now so that you can make an insert to rest the cone on to the candlestick.  Otherwise it will slide down and cover the candlestick.  I traced another circle inside the outer edge and then cut tabs all the way around the circle.  I used my glue runner on the tabs, then bent them up and placed this into the bottom of the cone.  It should fit about and inch up into the cone and may take a few adjustments to get it right.  Once I had it in and level I used the glue gun on a few of the tabs to secure it permanently.

If I had this to do over I would probably cover the cone with green paper and then add the Easter Grass, but you know what they say about hindsight!!!  I used spray adhesive and then lightly covered the cone with grass.  You will add more grass after gluing on the eggs to fill in the holes so don't worry about the white showing through.  Of course, if you cover the cone with green paper that would solve that problem!

Using a glue gun and generous amounts of glue, start adhering the eggs.

After they are all glued on you will need to fill in the gaps with more grass.  I just bunched up several strands, hit it with the glue gun and stuffed it in the holes.

Wishing you all a very Blessed Easter!